Siemens SINAMICS G110M - Page 33

Table 3-4 Description and location of interfaces
Item Description Item Description
1
Power Module
13
Blanking plate - to seal the opposite side of the Terminal
Housing from which the CPI has been 󹪝tted.
2
Interface cover
14
Cable gland or HANQ connections for left-side mounting or
daisy chaining the mains supply
3
Communications port 1
15
Potentiometer
4
Digital input 2 and digital input 3
16
Optical I/O connection
5
Communications port 2
17
Mini USB connection
6
Digital output 0 and digital output 1
18
Memory card reader
7
Analog input 0 and analog input 1
19
Braking resistor & motor connection terminals
8
External 24 Vdc OUT
20
Communications & Power Interface (CPI) interface ribbon
cable
9
External 24 Vdc IN
21
PROFIBUS/USS address and commissioning DIP switches 1
and 2
10
Digital input 0 and digital input 1
22
EM Brake & mains supply connection terminals
11
Mains supply connection
23
Control Module (CM)
12
Terminal housing
24
PROFIBUS/PROFINET/USS communications cable
Description
3.3 General layout SINAMICS G110M system
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 31