Siemens SINAMICS G110M - Page 331

Parameter
Parameter for Vdc_max control
The parameters di󹪜er depending on the motor control mode.
Table 8-74 Parameters for U/f control
Parameter Description Factory setting
p0210 Device supply voltage 400 V
p1280[D] Vdc controller con󹪝guration (U/f) 1
r1282 Vdc_max controller switch-on level (U/f) - V
p1283[0…n] Vdc_max controller, dynamic factor (U/f) 100%
p1294 Vdc_max controller automatic ON level detection (U/f) 0
Table 8-75 Parameter for vector control
Parameter Description Factory setting
p0210 Device supply voltage 400 V
p1240[0…n] Vdc controller con󹪝guration (vector control) 1
r1242 Vdc_max controller switch-in level - V
p1243[0…n] Vdc_max controller, dynamic factor 100%
p1254 Vdc_max controller automatic ON level detection 0
For additional information about this function, see the List Manual (function diagrams 6320 and
6220).
Manuals for your converter (Page 415)
Advanced commissioning
8.26 Motor and converter protection by limiting the voltage
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 329