Table 9-6 PROFIBUS eldbus
BF Explanation
Data exchange between the converter and control system is active
Fieldbus interface is not being used
The eldbus is improperly congured.
RDY In conjunction with a synchronously ashing LED RDY:
Converter waits until the power supply is switched o and switched on again after a
rmware update
No communication with higher-level controller
RDY In conjunction with an asynchronously ashing LED RDY:
Incorrect memory card
Firmware update failed
Firmware update is active
Table 9-7 Fieldbus AS-i
AS-i /
FLT
Explanation
System OK
AS-i master not connected
No communications between processors within the converter
Slave address 0
Converter trip
Alarms, faults and system messages
9.2 Operating states indicated via LEDs
Distributed converter for SIMOGEAR geared motors
348 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
To Next Page
Loading...
