13.Reconnect all the power supplies to the terminal housing.
14.The converter goes into the "ready-to-switch-on" state.
15.Set the new converter to suit the application:
– If the settings of the replaced Control Module are saved on an external storage medium,
transfer the settings via download.
Downloading the converter settings (Page 367)
– If there is no data backup of the replaced Control Unit, recommision the converter.
16.If you have not backed up your settings, then you must recommission the drive.
You replaced the Control Module.
❒
Corrective maintenance
10.1 Replacing the Control Module
Distributed converter for SIMOGEAR geared motors
366 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
To Next Page
Loading...
