Siemens SINAMICS G110M - Page 374

Function description
Procedure
1. Attach the Operator Panel to the converter.
2. Start the download.
8S'RZQORDG
0HQX
3DUDPHWHUV6HWXS'LDJQRVWLFV
8S
'RZQORDG
([WUDV6XSSRUW
'RZQORDGSDQHOWRGULYH
8SORDGGULYHWRSDQHO
'HOHWHSDQHOSDUDPHWHUVHW
'ULYHWRPHPRU\FDUG
0HPRU\FDUGWRGULYH
5HQDPHSDUDPHWHUVHW
3. Wait until the transfer is complete.
4. After loading, check whether the converter outputs Alarm A01028.
$FWLYHIDXOWVDODUPV
+LVWRU\
,GHQWLILFDWLRQ0DLQWHQDQFH
,2VWDWXV
&RPPXQLFDWLRQVVWDWXV
,2VLPXODWLRQ
'ULYHHQDEOHV
'LDJQRVWLFV
0HQX
3DUDPHWHUV6HWXS'LDJQRVWLFV
8S
'RZQORDG
([WUDV6XSSRUW
– Alarm A01028:
The loaded settings are not compatible with the converter.
Delete the alarm with p0971 = 1.
Recommission the drive.
– No alarm A01028: Proceed with the next step.
5. Back up the settings so that they are protected against power failure.
0HQX
3DUDPHWHUV6HWXS'LDJQRVWLFV
8S
'RZQORDG
([WUDV6XSSRUW
([WUDV
'ULYHIDFWRU\UHVHW
6DIHIDFWRU\UHVHW
'HIDXOWGDWDVHW
3DUDPHWHUVDYLQJPRGH
6DYH5$0WR520
6WDWXVVFUHHQZL]DUG
'ULYHLGHQWLW\
3DUDPHWHUVHWWLQJV
3DQHOVHWWLQJV
6. Select menu "Parameter".
0HQX
3DUDPHWHUV6HWXS'LDJQRVWLFV
8S
'RZQORDG
([WUDV6XSSRUW
3DUDPHWHUV
Parameter groups
Search by number
My parameters
Changed parameters
Parameter filter
Corrective maintenance
10.2 Downloading the converter settings
Distributed converter for SIMOGEAR geared motors
372 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL