Correcting a failed upgrade or downgrade
To correct a failed rmware upgrade or downgrade you can check the following:
• Does the rmware version fulll the requirements of your converter?
– For an upgrade at least V4.7.x.
– For a downgrade at least V4.7.
• Have you inserted the card properly?
• Does the card contain the correct rmware?
• Repeat the appropriate procedure.
Corrective maintenance
10.4 Firmware upgrade and downgrade
Distributed converter for SIMOGEAR geared motors
386 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL
To Next Page
Loading...
