Terminal Housing dimensions and xing points
The Terminal Housing of the G110M system replaces the existing terminal box on the connected
motor. There are three dierent types of the Terminal Housings and they are shown in the
following gure. All three Terminal Housings have the same external dimensions:
• Height: 92 mm.
• Width: 161 mm
• Depth: 171 mm
Please note that the xing points (for securing the Terminal Housing to the motor) are indicated
in RED. The FS 80/90 Terminal Housing has six xing points, two of which are marked in GREEN
and indicated by the ground symbol. These xing points provide the correct earthing between
the Terminal Housing and the motor and MUST be used.
All xing bolts for the Terminal Housing are supplied with each Terminal Housing.
Note
FS 80/90 Terminal Housing 21 mm xing screws
The 21 mm xing screws for the FS 80/90 Terminal Housing are not supplied with the product.
)6
PPPPPP
PP
PP
)6)6
Figure 4-3 Terminal Housing dimensions
Motor dimensions
There are a large number of motors associated with the G110M system, with each motor being
uniquely congured for the user requirements.
Installation
4.1 Mechanical Installation
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 39
To Next Page
Loading...
