Siemens SINAMICS G110M - Page 74

PROFIBUS terminal diagram
1RWFRQQHFWHG
'DWD$1
1RWFRQQHFWHG
'DWD%3
)XQFWLRQDO(DUWK





X03
352),%86'3,1
2
4
5
1
3
M12 connector, 5 Pole, male
1RWFRQQHFWHG
'DWD$1
1RWFRQQHFWHG
'DWD%3
)XQFWLRQDO(DUWK





X04
352),%86'3287
2
4
5
1
3
M12 connector, 5 Pole, female
PROFINET terminal diagram
7UDQVPLVVLRQ'DWD
5HFHLYH'DWD
7UDQVPLVVLRQ'DWD
5HFHLYH'DWD




X03
352),1(73RUW



M12 connector, 4 Pole, female
7UDQVPLVVLRQ'DWD
5HFHLYH'DWD
7UDQVPLVVLRQ'DWD
5HFHLYH'DWD




X04
352),1(73RUW



M12 connector, 4 Pole, female
AS-i terminal diagram
$6L
$8;
$6L
$8;
)XQFWLRQDO(DUWK
$6L&RQQHFWLRQ





X03





M12 connector, 5 Pole, female
24V Power supply - USS, PROFIBUS, PROFINET
The unswitched 24 V power supply (1L+) is required for the device to function.
• Use a power supply with PELV (Protective Extra Low Voltage).
• For applications in USA and Canada: Use a power supply NEC Class 2.
• The 0 V of the power supply must be connected with low resistance to the PE of the system.
The switched 24 V (2L+) supplies the two digital outputs. Switching o󹪜 brings all of the actuators
connected to the digital outputs into the no-voltage state.
Installation
4.3 Electrical Installation
Distributed converter for SIMOGEAR geared motors
72 Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL