Siemens SINAMICS G110M - Page 79

+DQ4YDULDQWZLULQJH[DPSOH*ODQGHGYDULDQWZLULQJH[DPSOH
1RWH
7KHFDEOHFODPSKDVEHHQUHPRYHGIURPWKH+DQ4YDULDQWWRDOORZWKHPDLQVWHUPLQDOZLULQJWREHHDVLO\YLVLEOHWKHFDEOH
FODPSPXVWEHLQSODFHEHIRUHSRZHULVDSSOLHGWRWKHV\VWHP
Figure 4-14 Daisy chaining power between converters
Note
Fault protection when insulation fails in the motor circuit at the output side
In case of insulation failure in the motor circuit, the overcurrent trip of the converter meets the
requirements of IEC 60364-4-41:2005/AMD1:2017 Section 411 and Annex D for protection
against electric shock.
• Observe the installation speci󹪝cations for this converter.
• Ensure the continuity of the protective conductor.
• Observe the applicable installation standards.
Installation
4.3 Electrical Installation
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL 77