8
03.96
8.1 Alarm and message texts
8-194
Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
The associated text is given in inverted commas with the position parameters.
S The characters ” and # must not be used in alarm texts.
The character % is reserved for displaying parameters.
S If the user wishes to use an existing text, a reference to the appropriate
alarm text can be inserted. 6-digit alarm number instead of “text”.
S The alarm text file may contain comment lines which must start with “//”. The
maximum length of the alarm text is 110 characters for a 2-line display. If the
text is too long, it is cut off and the symbol “*” added to indicate missing text.
S Parameter “%K”: Channel number (2nd digit of alarm number)
Parameter “%A”: The parameter is replaced by the signal group no. (e.g.
axis no., user area no., sequential controller no.)
Parameter “%N”: Signal number
Parameter “%Z”: Status number
Text or alarm number
8 Alarm and Messa
e Texts
To Next Page
Loading...
Need help?
General
