11
03.96
11.7 Data backup with VALITEK streamer on the MMC101/102/103 (SW 5.3 and lower)
11-277
 Siemens AG 2000 All Rights Reserved
SINUMERIK 840D Installation and Start-Up Guide (IAD) – 04.00 Edition
PLEASE SELECT:
1 Select VALITEK Streamer Type
2 Test Connection to Streamer
3 Backup System
4 Backup User Data
5 Restore from Tape
6 Uninstall MMC102/103 (Delete Files)
7 Return to Main Menu
Your Choice [1,2,3,4,5,6,7]?
4. Press key 1
The following menu is displayed:
*** No Streamer configured ***
Please select (new) Streamer type:
1 Valitek PST–160
2 Valitek PST
2
–M1200
3 Return to previous Menu
Your Choice [1,2,3]?
5. Select a streamer type, e.g. no. 2 Valitek PST
2
–M1200. The streamer type is
selected and you are taken back to the selection menu.
PLEASE SELECT:
1 Select VALITEK Streamer Type
2 Test Connection to Streamer
3 Backup System
4 Backup User Data
5 Restore from Tape
6 Uninstall MMC102/103 (Delete Files)
7 Return to Main Menu
Your Choice [1,2,3,4,5,6,7]?
6. If the streamer is connected you can check the connection. To do this select
menu item 2
A message about the streamer type is displayed:
*** Current Configuration: Valitek PST
2
–M1200 ***
Press any key to continue ...
The test run then starts.
11 Data Backup
To Next Page
Loading...
