Detailed description
2.12 Block descriptions
Basic logic functions: PLC basic program solution line (P3 sl)
134 Function Manual, 11/2006, 6FC5397-0BP10-2BA0
PI service: CREATO
Function Create tool:
Creation of a tool with specification of a T number. The tool is entered as existing in the tool
directory area (TV). The first "cutting edge" D1 (with zero contents) is created for tool offsets
in the TO block. D1 (with zero contents) is also created for the OEM "cutting edge" data in
the TUE block - if one is present. If a TU block exists, it will contain the data set for the tool.
Parameterization
Signal Type Range of values Significance
PIService ANY PI.CREATO Create tool
Unit INT 1 - 10 TOA
WVar1 INT T number
PI service: DELECE
Function Delete a tool cutting edge:
If the T number of an existing tool is specified in parameter “T number” in the PI service, then
a cutting edge is deleted for this particular tool (in this case, parameter “D number” (number
of cutting edge to be created) has a value range of 00001–00009). If a positive T number is
specified as a parameter and the tool for the T number entered does not exist, then the PI
service is aborted. If a value of 00000 is entered for the T number (model of absolute D
numbers), then the D number value range might extend from 00001 to 31999. If the specified
cutting edge does not exist, then the PI service is aborted in both cases.
Parameterization
Signal Type Range of values Significance
PIService ANY PI.DELETE Delete cutting edge
Unit INT 1 - 10 TOA
WVar1 INT T number of tool for which cutting
edge must be created. A setting of
00000 states that the cutting edge
should not refer to any particular tool
(absolute D number).
WVar2 INT 1 - 9 or
01 - 31999
Edge number of cutting edge that must
be deleted
To Next Page
Loading...
Need help?
General
