Scale parameters and functions of the belt scale
8.17 DR 17 Control analog output
SIWAREX WP241
116 Manual, 04/2014, A5E33713528A
DR 17 Control analog output
If data record DR 17 is configured as the source for the analog output (see Analog output
source (Page 102)), specifying a control output sends a corresponding output current at the
analog output.
● In data record DR 7, check that "Control by DR17" has been configured as the source for
the analog output
● Check the analog output configuration (see Analog output source (Page 102))
● Enter a value in data record DR 17
● Transfer the data record to the scale
Table 8- 15 Assignment of data record 17
Data record
Contains no. of data record USHORT 2 r 17 - - 1588
Data record length information
Application Information about which application
the data record belongs to
USHORT 2 r 104 - - 1590
Version
Information about current data record
USHORT 2 r 1 1 65635 1591
Analog output
specification
Value which is to be output (only
relevant if source is "External
specification", see DR 7)
FLOAT 4 rw 0 - - 1592
Analog output specification
The value to be entered must be between the start value (Page 102) and the end value
(Page 103) of the analog output.
To Next Page
Loading...
Need help?
General
