Scale parameters and functions of the belt scale
8.8 DR 6 Limits
SIWAREX WP241
94 Manual, 04/2014, A5E33713528A
Negative and positive zero offset in %
Zeroing sets the current weight of the scale and the belt load to zero. The specification is
made in % of the nominal belt load. The range refers to the original zero point of the last
calibration.
In the case of sales for legal trade operation, the maximum zero offset is 4%.
The smallest totalized value is the smallest value which may be recorded with verification
capability.
Dropping below the minimum flow rate is displayed in the status area of the scale. The
specification is made in % of the design flow rate.
Exceeding the maximum flow rate is displayed in the status area of the scale. The
specification is made in % of the design flow rate.
Delay for flow rate limits
Reaching the maximum flow rate is displayed in the status area of the scale only following
expiry of the delay. The specification is made in ms.
Dropping below the minimum belt speed is displayed in the status area of the scale. The
specification is made in % of the nominal belt speed which was specified during
commissioning or calculated.
Exceeding the maximum belt speed is displayed in the status area of the scale. The
specification is made in % of the nominal belt speed which was specified during
commissioning or calculated.
To Next Page
Loading...
Need help?
General
