Siemens SIWAREX WP241 - Page 152

Command lists
10.2 Command lists
SIWAREX WP241
152 Manual, 04/2014, A5E33713528A
Table 10- 6 Totalizing commands of SIWAREX WP241
Command
code
Command Description
651 Start totalizing Starts the totalizing. In the basic state, totalizing of the module is always
active and must be specifically deactivated by the user (command 652).
652 Stop totalizing Stops all totalizers except totalizer S6. Can be used for (material) tests which
should not be included in the total balance.
670
Reset main totalizer S2
Resets the main totalizer to 0
671
Reset totalizer S3
Resets totalizer 3 to 0
672
Reset totalizer S4
Resets totalizer 4 to 0
673
Reset totalizer S5
Resets totalizer S5 to 0
674
Reset totalizer S6
Resets totalizer S6 to 0
675
Reset totalizers S3...S6
Simultaneously resets totalizers S3 to S6 to 0