Simrad GO XSE User Manual

Radar threshold
The threshold sets required signal strength for the lowest radar
signals. Radar returns below this limit are filtered and are not
displayed.
Default value: 30%.
Target expansion
Target expansion increases the length of targets in range, making
them easier to see.
Rejecting radar interference
Interference could be caused by radar signals from other radar units
operating in the same frequency band.
A high setting reduces the interference from other radars.
In order not to miss weak targets, the interference rejection should
be set to low when no interference exists.
Target separation
(Broadband 4G and Halo Radar only)
The Target separation control allows you to control the target
discrimination of the radar (separation between objects is more
prominent).
Fast scan
(Broadband and Halo radar only).
Sets the speed of the radar antenna rotation. This option gives faster
target updates.
Ú
Note: Maximum speed may not be achieved depending on the
radar Settings, Mode, and Range selected. The radar will only
rotate as fast as the current control settings allow.
Sea State
Set the Sea State control according to current sea conditions for
best sea clutter rejection.
Target boost
(3G and 4G Broadband, and Pulse Radar only)
Radar | GO XSE Operator Manual
101

Simrad GO XSE Specifications

General

GPS	Yes
Chartplotter	Yes
NMEA 2000	Yes
Wi-Fi	Yes
Bluetooth	Yes
Waterproof Rating	IPX7
Operating Voltage	12V DC
Sonar	Yes (built-in)
Cartography	C-MAP, Navionics
Mounting Type	Bracket or Flush Mount
Screen Size	7-inch, 9-inch
Screen Resolution	800 x 480 pixels