Transmit
The scanner is on and transmitting. Detected targets are drawn on
the radar PPI (Plan Position Indicator).
Ú
Note: You can also put the radar in transmit mode from the
System Controls dialog.
Radar Range
You adjust radar range by selecting the zoom icons on the radar
panel.
Dual range
(Broadband 4G and Halo Radar only)
When connected to a Broadband 4G or Halo radar, it is possible to
run the radar in Dual Range mode.
The radar appears in the radar sources menu as two virtual radar
sources A and B. Range and radar controls for each virtual radar
source are fully independent and the source can be selected for a
particular chart or radar panel in the same manner as dual radar
described in "Selecting the radar source" on page 93.
Ú
Note: Some controls that are related to physical properties of
the radar itself are not independent of source. These are Fast
Scan, Antenna Height and Bearing alignment.
MARPA is fully independent and up to 10 targets may be tracked for
each virtual radar source.
Up to two independent Guard Zones may also be defined for each
virtual radar source.
Using the cursor on a radar panel
By default, the cursor is not shown on a radar panel.
When you position the cursor on the radar panel, the cursor
position window is activated and the cursor menu options are
displayed.
To remove the cursor and cursor elements from the panel, select
Clear cursor or press the X key.
Radar | GO XSE Operator Manual
95
To Next Page
Loading...
Need help?
General
