Ú
Note: If the MOB function is already active, this will be
terminated and replaced by the new route towards the AIS
SART position!
Ú
Note: If the AIS stops receiving the AIS SART message, the AIS
SART remains in the Vessels list for 10 minutes after it receives
the last signal.
If you select the AIS SART icon on the chart panel, then you can see
the AIS MOB details.
Vessel alarms
You can define several alarms to alert you if a target shows up
within predefined range limits, or if a previously identified target is
lost.
Dangerous vessel
Controls whether an alarm will be activated when a vessel comes
closer than the distance for CPA within the time limit for TCPA. Refer
to "Defining dangerous vessels" on page 156.
AIS vessel lost
Sets the range for lost vessels. If a vessel is lost within the set range,
an alarm occurs.
Ú
Note: The check box controls whether the alarm pop-up box is
displayed and if the siren goes on. The CPA and TCPA define
AIS | GO XSE Operator Manual
153
To Next Page
Loading...
Need help?
General
