You can perform further setup using the system settings option and
later change settings made with the setup wizard.
Standby mode
In Standby mode, the Sonar and the backlight for screen and keys
are turned off to save power. The system continues to run in the
background.
You select Standby mode from the System Controls dialog.
Switch from Standby mode to normal operation by a short press on
the Power key.
Display illumination
Brightness
The display backlighting can be adjusted at any time from the
System Controls dialog.
You can also cycle the preset backlight levels by short presses on
the Power key.
Night mode
The night mode option optimizes the color palette and backlight for
low light conditions.
Ú
Note: Details on the chart may be less visible when the Night
mode is selected!
Wireless
Provides wireless connection options dependent on the status of
the wireless. For example, connect to a hotspot or change to access
point. For option explanations refer to "Wireless connection" on page
143.
Locking the touchscreen
You can temporarily lock a touchscreen to prevent accidental
operation of the system. Lock the touchscreen when large amounts
of water are on the screen, for example, in heavy seas and weather.
This feature is also useful when cleaning the screen while the unit is
turned on.
You lock the touchscreen from the System Controls dialog.
22
Basic operation | GO XSE Operator Manual
To Next Page
Loading...
Need help?
General
