autopilot mode. Refer to "Using the autopilot in an EVC system" on page
87.
Autopilot indication on the pages
1 Control bar
2 Autopilot controller
3 Autopilot indication in Status bar
Autopilot mode indication in the Status bar
The Status bar shows autopilot information as long as an autopilot
computer is connected to the network.
Icons are included if the autopilot is passive or locked by another
autopilot control unit.
Autopilot controller
Select Autopilot in the Control bar to activate the Autopilot
controller.
The Autopilot controller has a fixed position on the left-side of the
page.
Close the Autopilot controller by selecting Close/Back on the
Autopilot controller.
76
Autopilot | GO XSE Operator Manual
To Next Page
Loading...
