Simrad GO XSE User Manual

You can also close the Autopilot controller by selecting Autopilot or
another button on the Control bar.
Open it again by selecting Autopilot on the Control bar.
The following Autopilot controller pages are available:
• Autopilot controller, showing active mode, heading, rudder and
various steering information depending on active autopilot
mode. Manual adjustments to the set heading can only be made
when the port and starboard arrow indicators are illuminated red
and green.
• Mode selection, includes access to turn pattern selection.
• Turn pattern selection, available when in Heading Hold mode.
Autopilot controller Mode selection Turn pattern selection
The Autopilot panel
The autopilot panel is used to display navigation data. It can be
shown as a full screen panel, or in a multi-panel page.
Ú
Note: To make the autopilot panel available, activate the show
autopilot features option in the Advanced, Features section of
the System Settings dialog.
The number of data fields included in the autopilot panel is
dependent on available panel size.
Autopilot | GO XSE Operator Manual
77

Simrad GO XSE Specifications

General

GPS	Yes
Chartplotter	Yes
NMEA 2000	Yes
Wi-Fi	Yes
Bluetooth	Yes
Waterproof Rating	IPX7
Operating Voltage	12V DC
Sonar	Yes (built-in)
Cartography	C-MAP, Navionics
Mounting Type	Bracket or Flush Mount
Screen Size	7-inch, 9-inch
Screen Resolution	800 x 480 pixels