Simrad GO XSE User Manual

Data fields
The following abbreviations are used in the autopilot panel:
CTS Course to steer
DTD Distance to destination
DTW Distance to next waypoint
SOG Speed over ground
COG Course over ground
XTE Cross track error (L: left or R: right)
Autopilot modes
The autopilot has several steering modes. The number of modes
and features within the mode depend on the autopilot computer,
the boat type and available inputs, as explained in the description of
the following steering modes.
Standby mode
Standby mode is used when you steer the boat at the helm. Switch
the autopilot to Standby mode from any operation by selecting the
Standby mode button in the Autopilot controller or using a physical
standby key.
Non-Follow Up (NFU, Power steering)
In NFU mode you use the port and starboard arrow buttons in the
Autopilot controller to control the rudder. The rudder will move as
long as the button is pressed.
• Activate NFU mode by selecting the port or starboard arrow
button in the Autopilot controller when the autopilot is in
Standby or FU mode.
78
Autopilot | GO XSE Operator Manual

Simrad GO XSE Specifications

General

GPS	Yes
Chartplotter	Yes
NMEA 2000	Yes
Wi-Fi	Yes
Bluetooth	Yes
Waterproof Rating	IPX7
Operating Voltage	12V DC
Sonar	Yes (built-in)
Cartography	C-MAP, Navionics
Mounting Type	Bracket or Flush Mount
Screen Size	7-inch, 9-inch
Screen Resolution	800 x 480 pixels