Simrad GO XSE User Manual

Audio server
If multiple audio sources are connected to the same network, one of
the devices must be selected as the Audio server. If only one of the
devices is present, it is the selected Audio server by default.
Operating the audio system
1. Select Audio in the Control bar to open the Audio controller
2. Select the Audio source button and then select the audio
source
-
Number of sources depends on the active audio server
3. Use the controller buttons to control your audio system
For an overview of audio control buttons and tools, refer to "Audio
control buttons" on page 161. Also see "Audio Tools" on page 162.
For available options, refer to the documentation following your
audio equipment.
The Audio controller
Activate the Audio controller by selecting Audio in the Control bar.
The control buttons, tools and options vary from one audio source
to another as described later in this chapter.
1 Audio controller
2 Audio source
160
Audio | GO XSE Operator Manual

Simrad GO XSE Specifications

General

GPS	Yes
Chartplotter	Yes
NMEA 2000	Yes
Wi-Fi	Yes
Bluetooth	Yes
Waterproof Rating	IPX7
Operating Voltage	12V DC
Sonar	Yes (built-in)
Cartography	C-MAP, Navionics
Mounting Type	Bracket or Flush Mount
Screen Size	7-inch, 9-inch
Screen Resolution	800 x 480 pixels