Simrad GO XSE User Manual

Autopilot
If a compatible autopilot computer is connected to the system,
autopilot functionality is available in the system.
The system does not allow for more than one autopilot computer
on the network.
The display unit automatically detects the autopilot computer
available on the network and presents settings, configuration and
user options for the connected computer.
For details about installing and configuring an autopilot computer,
refer to the separate manuals that come with the autopilot
computer.
Safe operation with the autopilot
Warning: An autopilot is a useful navigational aid,
but DOES NOT replace a human navigator.
Warning: A physical standby key should be available
for the autopilot.
Activating the autopilot
Activate the autopilot from any panel by selecting the autopilot
option in the Control bar, followed by selecting a mode in the
Autopilot controller.
The autopilot can also be activated in navigation mode from
applications when you select to navigate to the cursor, a waypoint,
or a route.
Switching from automatic mode to manual
steering
You switch the autopilot to Standby mode from any automatic
operation mode from the Autopilot controller or using a physical
standby key.
Ú
Note: If the unit is connected to an EVC system via the SG05,
you can take manual control of the steering regardless of the
8
Autopilot | GO XSE Operator Manual
75

Simrad GO XSE Specifications

General

GPS	Yes
Chartplotter	Yes
NMEA 2000	Yes
Wi-Fi	Yes
Bluetooth	Yes
Waterproof Rating	IPX7
Operating Voltage	12V DC
Sonar	Yes (built-in)
Cartography	C-MAP, Navionics
Mounting Type	Bracket or Flush Mount
Screen Size	7-inch, 9-inch
Screen Resolution	800 x 480 pixels