All transducers measure water depth from the transducer to the
bottom. As a result, water depth readings do not account for the
distance from the transducer to the lowest point of the boat in the
water or from the transducer to the water surface.
To show the depth from the lowest point of the boat to the bottom,
do the following. Before setting the Structure offset, measure the
distance from the structure transducer to the lowest point of the
boat in the water. If, for example, the distance is 0.3 m (1 ft), it will be
input as (minus) - 0.3 m (-1 ft).
To show the depth from the water surface to the bottom, do the
following. Before setting the Structure offset, measure the distance
from the structure transducer to the water surface. If, for example,
the distance is 0.3 m (1 ft), it will be input as (plus) 0.3 m (1 ft).
A setting of 0 (zero) causes the depth displayed to be the distance
from the transducer to the bottom.
Installation
Used for installation and setup. See the separate GO XSE Installation
manual
ForwardScan Installation
Used for ForwardScan installation and setup. Refer to the "ForwardScan
setup" on page 140.
Echosounder | GO XSE Operator Manual
125
To Next Page
Loading...
Need help?
General
