Connect to a wireless hotspot
Displays the Wireless device dialog that you can use to connect the
wireless functionality to a wireless hotspot.
Remote controllers
When a wireless device (smart phone or tablet) is connected, it
should appear in the Remote controllers list. Selecting Always
allow means the device can automatically connect without
needing a password each time. This menu also allows you to
disconnect devices that no longer require access.
Wireless devices
This dialog shows the internal wireless and any connected WIFI-1
devices, as well as their IP and channel number. Selecting the
internal wireless or a WIFI-1 device provides additional detail.
Ú
Note: WIFI-1 is available if the unit has a Radar connection on
the back of the unit. The Radar connection can be used as an
Ethernet connection for the WIFI-1.
To view and change internal wireless detail values (Network Name
(SSID), Network Key, or Channel) the internal wireless must be in
Access Point (Internal Wifi) mode. To select a network (hotspot) to
connect to, the internal wireless must be in Client Mode. Use the
Mode option to change modes.
Wireless connection | GO XSE Operator Manual
147
To Next Page
Loading...
Need help?
General
