Safety information
1-4
1
CAUTION : TIPPING HAZARD
To reduce the risk of equipment instability, load each tray separately. Keep all other trays closed
until needed.
CAUTION HOT SURFACE
The inside of the printer might be hot. To reduce the risk of injury from a hot com ponent, allow the
surface to cool before touching it.
CAUTION PINCH HAZARD
To avoid the risk of a pinch injury, use caution in areas marked with this label.
Pinch injuries may occur around moving parts, such as gears, doors, trays, and covers.
CAUTION POTENTIAL INJURY
This product uses a laser. Use of controls or adjustments or performance of procedures other than
those specified in the User’s Guide may result in hazardous radiation exposure.
CAUTION POTENTIAL INJURY
This product uses a laser. Use of controls or adjustments or performance of procedures other than
those specified in the User’s Guide may result in hazardous radiation exposure.
This product is designed, tested, and approved to meet strict global safety standards with the use of specific
manufacturer’s components. The safety features of some parts may not always be obvious. The manufacturer is
not responsible for the use of other replacement parts.
Refer service or repairs, other than those described in the user documentation, to a service representative.
This product uses a printing process that heats the print media, and the heat may cause the media to release
emissions. You must understand the section in your operating instructions that discusses the guidelines for se
lecting print media to avoid the possibility of harmful emissions.
This product may produce small amounts of ozone during normal operation, and may be equipped with a filter
designed to limit ozone concentrations to levels well below the recommended exposure limits. To avoid high
ozone concentration levels during extensive usage, install this product in a well-ventilated area and replace the
ozone and exhaust filters if instructed to do so in the product maintenance instructions. If there are no
references to filters in the product maintenance instructions, then there are no filters requiring replacement for
this product.
SAVE THESE INSTRUCTIONS
To Next Page
Loading...
