Sindoh C300 - E-mail Setup; SMTP Server Configuration

Use printer menus
10-28
10
7. E‑mail
7.1 E‑mail Setup
Menu Item Description
Primary SMTP Gateway Type the IP address or host name of the primary SMTP server for
sending e‑mail.
Primary SMTP Gateway Port
1‑65535(25*)
Enter the port number of the primary SMTP server.
Secondary SMTP Gateway Type the server IP address or host name of your secondary or
backup SMTP server.
Secondary SMTP Gateway Port
1‑65535 (25*)
Enter the server port number of your secondary or backup SMTP
server.
SMTP Timeout
5–30 seconds (30*)
Set the time before the printer times out if the SMTP server does
not respond.
Reply Address Specify a reply address in the e‑mail.
Always use SMTP default Reply
Address
On
Off*
Always use the default reply address in the SMTP server.
Use SSL/TLS
Disabled*
Negotiate
Required
Specify whether to send e‑mail using an encrypted link.
Require Trusted Certificate
On*
Off
Require a trusted certificate when accessing the SMTP server.
SMTP Server Authentication
No authentication required*
Login / Plain
NTLM
CRAM‑MD5
Digest‑MD5
Set the authentication type for the SMTP server.
Device‑Initiated E‑mail
None*
Use Device SMTP Credentials
Specify whether credentials are required for device‑initiated e‑mail.
Device Userid Specify the user ID and password to connect to the SMTP server.
Device Password
NTLM Domain Specify the domain name for the NTLM security protocol.
Note: An asterisk (*) next to a value indicates the factory default setting.
7.2 E‑mail Defaults
Menu Item Description
Subject Specify the e‑mail subject and message.
Message
File Name Specify the file name for the scanned image.
Note: An asterisk (*) next to a value indicates the factory default setting.