Sindoh C300 - 10.3 Ethernet

Use printer menus
10-42
10
Menu Item Description
PS SmartSwitch
On*
Off
Set the printer to switch automatically to PS emulation when a print job
requires it, regardless of the default printer language.
Note
‑ If PS SmartSwitch is off, then the printer does not examine incoming
data and uses the default printer language specified in the Setup
menu.
Mac Binary PS
Auto*
On
Off
Set the printer to process Macintosh binary PostScript print jobs.
Note
‑ On processes raw binary PostScript print jobs.
‑ Off filters print jobs using the standard protocol.
Note: An asterisk (*) next to a value indicates the factory default setting.
10.3 Ethernet
Menu Item Description
Network Speed Show the speed of an active network adapter.
IPv4
Enable DHCP
On*
Off
Enable Dynamic Host Configuration Protocol (DHCP).
Note
‑ DHCP is a standard protocol that allows a server to distribute IP
addressing and configuration information to clients in a dynamic
manner.
IPv4
Set Static IP Address
IP Address
Netmask
Gateaway
Set the static IP address of your printer.
IPv6
Enable IPv6
Off
On*
Enable IPv6 in the printer.
IPv6
Enable DHCPv6
Off*
On
Enable DHCPv6 in the printer.
IPv6
Stateless Address
Autoconfiguration
Off
On*
Set the network adapter to accept the automatic IPv6 address
configuration entries provided by a router.
IPv6
DNS Address
Specify the DNS server address.
IPv6
Manually Assigned IPV6 Address
Assign the IPv6 address.
Note
‑ This menu item appears only in some printer models.
IPv6
Manually Assigned IPv6 Router
Assign the IPv6 address.
Note
‑ This menu item appears only in some printer models.
Note: An asterisk (*) next to a value indicates the factory default setting.