Sindoh C300 - Paper and Media Configuration; Tray Configuration; Media Configuration

Use printer menus
10-18
10
4. Paper
4.1 TrayConguration
Menu Item Description
Default Source
Tray [x] (1*)
Manual Paper
Manual Envelope
Set the paper source for all print jobs.
Paper Size / Type
Tray [x] (1*)
Manual Paper
Manual Envelope
Specify the paper size or paper type loaded in each paper source.
Substitute Size
Off
Letter/A4
All Listed*
Set the printer to substitute a specified paper size if the requested size is
not loaded in any paper source.
Note
‑ Off prompts the user to load the required paper size.
‑ Letter/A4 prints an A4‑size document on letter when loading letter, and
letter‑size jobs on A4 paper size when loading A4.
‑ All Listed substitutes Letter/A4.
Note: An asterisk (*) next to a value indicates the factory default setting.
4.2 MediaConguration
Universal Setup
Menu Item Description
Units of Measure
Inches
Millimeters
Specify the unit of measurement for the universal paper.
Note
‑ Inches is the U.S. factory default setting. Millimeters is the international
factory default setting.
Portrait Width
3.00–14.17 inches (8.50*)
76–360 mm (216*)
Set the portrait width of the universal paper.
Portrait Height
3.00–14.17 inches (14*)
76–360 mm (356*)
Set the portrait height of the universal paper.
Feed Direction
Short Edge*
Long Edge
Set the printer to pick paper from the short edge or long edge direction.
Note
‑ Long Edge appears only when the longest edge is shorter than the
maximum width supported.
Note: An asterisk (*) next to a value indicates the factory default setting.