Sindoh C300 - TCP;IP and Security Settings

10-43
Use printer menus
10
Menu Item Description
IPv6
Address Prefix 0–128 (64*)
Specify the address prefix.
IPv6
All IPv6 Addresses
Show all IPv6 addresses.
IPv6
All IPv6 Router Addresses
Show all IPv6 router addresses.
Network Address
UAA
LAA
Show the printer Media Access Control (MAC) addresses: Locally
Administered Address (LAA) and Universally Administered Address (UAA).
Note
‑ You can change the printer LAA manually.
PCL SmartSwitch
Off
On*
Set the printer to switch automatically to PCL emulation when a print job
requires it, regardless of the default printer language.
Note
‑ If PCL SmartSwitch is off, then the printer does not examine incoming
data and uses the default printer language specified in the Setup
menu.
PS SmartSwitch
On*
Off*
Set the printer to switch automatically to PS emulation when a print job
requires it, regardless of the default printer language.
Note
‑ If PS SmartSwitch is off, then the printer does not examine incoming
data and uses the default printer language specified in the Setup
menu.
Mac Binary PS
Auto*
On
Off
Set the printer to process Macintosh binary PostScript print jobs.
Note
‑ On processes raw binary PostScript print jobs.
‑ Off filters print jobs using the standard protocol.
Energy Efficient Ethernet
Off
On
Auto*
Reduce power consumption when the printer does not receive data from
the Ethernet network.
Note: An asterisk (*) next to a value indicates the factory default setting.
10.4 TCP/IP
Note
‑ This menu appears only in network printers or printers attached to print servers.
Menu Item Description
Set Hostname Set the current TCP/IP host name.
Domain Name Set the domain name.
Allow DHCP/BOOTP to update NTP
server
On*
Off
Allow the DHCP and BOOTP clients to update the NTP settings of the
printer.
Zero Configuration Name Specify a service name for the zero configuration network.
Enable Auto IP
On*
Off
Assign an IP address automatically.
Note: An asterisk (*) next to a value indicates the factory default setting.