SKF KFGL - Page 86

10. KFGL control unit
KFGL
10.2.3 Config. - Configuration mode
Configuration mode is started by selecting
<Config.> in the main menu and pressing the
ENTER key. First you need to specify whether
you want to edit the configuration data or view
it only. If you want to edit the configuration
data, a password is requested.
Note!
When the correct password is entered,
all currently running lubrication proce-

mode starts.
If the configuration data will be viewed and not
modified, the <Config. menu> will appear upon
confirmation by pressing the ENTER key.
No changes can be made in this mode.
Selection in configuration mode is
performed by briefly pressing one of the
keys.
Configuration menu, table 1 of 2
Step Key Display Description
1
Entry mask/language selection
The German version is active by default (flashing).
Press the “up” arrow key to change to the English
version.
Press the ENTER key
2
Main menu
Use the arrow key to select “Config.”
Press the ENTER key to go to the
Config. menu.
3
Config. menu
Display
Press the ENTER key to go to the Configuration
menus. Here you can view the configurations for:
System
Settings
Inputs
Outputs
The active configuration or selection will flash.
Data cannot be entered or changed in display
mode.
English
German
Info
Config
Status
Display
Edit
Page 86
EN