14.7 Replace the control unit
8.
Programme the control box, see RESET: Acknowledge faults on control box » 140.
9.
Test the electric adjustments to ensure they work correctly!
10.
Replace the control box in its holder and secure the holder again with the two screws
on the underside of the linen holder.
Installation is complete.
The terminals of the control unit (LINAK CO61 control unit) are located at the head end under
the backrest and are assigned as follows.
Image17:
Linak CO61 control unit
[1] Mattress base height, foot end [2] Thigh rest
[3] Mattress base height, head end [4] Backrest
[5] Handset/control units (Open-
Bus
®
)
[6] Rechargeable battery
[7] Power plug [8] Cover securing clips
Replacement of electrical components
Instruction Manual 122
To Next Page
Loading...
