9.9.2 Trendelenburg Position on the Control Box
9.9.2.1 Reverting to horizontal bed position
9.9.3 Reverse-Trendelenburg Position on the Control Box
3 Press the DOWN button until the bed
is set to the Trendelenburg position.
4 To obtain a reverse-Trendelenburg po-
sition, press the UP button.
Once the mattress base has reached
a horizontal position, an automatic
stop is made. Release the button and
then press the button again to contin-
ue adjustment to a Trendelenburg or
reverse-Trendelenburg position.
The display indicates the angle in in-
crements of 6° - 12° and max.
•
This position can be set from any mattress base height.
•
The maximum angle of tilt is up to 17° in every direction.
•
If necessary, the height will be automatically adjusted.
1 Press the unlock button and the Trendelenburg position but-
ton until the full extent or the desired position is reached.
1 Press the unlock button and the reverse-Trendelenburg but-
ton at the same time.
The mattress base automatically moves to the horizontal po-
sition, and stops there.
•
This position can be set from any mattress base height.
•
If necessary, the height will be automatically adjusted.
Use/routine
81 Instruction Manual
To Next Page
Loading...
Need help?
General
