Stiegelmeyer Seta pro - Full-Length Safety Sides

9.12.1 Full-Length Safety Sides
9.12.1.1 Raising
9.12.1.2 Lowering
Please note that the use of full-length safety sides is only possible in conjunction with the
Base head and footboard.
The following section describes how to raise one of the safety sides. The safety sides on the
other side of the bed are raised in exactly the same way.
1 At one end of the bed, raise the up-
per bar of the safety side as far as it
will go. The bar engages with an au-
dible click when it is fully raised.
2 Check that the safety side is securely
and firmly positioned by pressing down
on the top bar.
3 Repeat this procedure at the other end of the bed.
The following section describes how to lower one of the safety sides. The safety sides on the
other side of the bed are lowered in exactly the same way.
Use/routine
Instruction Manual 88