9.5.3 On the control box
When the intermediate stop function is activated, the backrest stops in the intermediate
stop position that has been set. To continue, release the UP/DOWN adjustment button
and then press this button again.
Switching ON/OFF:
1.
Switch to the “medical staff control level”
• Hold the end of the handset briefly against the magnetic unlocking key.
2.
Select or with the toggle switch and confirm your selection with the
UP button
Reprogramming the intermediate stop angle
1.
Set the intermediate backrest stop to the desired position
2.
Switch to the “technician control level”
•
To find out how to switch to the technician control level, see refer to chapter On
the LCD handset » 105, steps 1-3.
3.
Select the icon with the toggle switch and confirm your selection with the UP
button
A conformation beep sounds for one second
The original position is overwritten
1 Press the backrest UP button and the un-
lock button at the same time to raise the
backrest.
2 Press the backrest DOWN button at the
same time as the unlock button to move
the backrest back to the normal position.
Use/routine
75 Instruction Manual
To Next Page
Loading...
