5 Operation
Handling loads
– Tilt the fork arms or lift mast until the fork
arms are horizontal.
– Raise the fork carriage to a position for clear
entry into the pallet or load.
– Release the brake.
– Drive up to the racking until the truck chassis
is as close as possible.
–Brake.
– Extend the reach carriage until the fork back
is resting on the load.
The load centre of gravity must be midway
between the fork arms.
– Slowly raise the f
ork carriage until the load
is lifted clear of
the racking.
– Tilt the fork tips or lift mast to the drive side
only as far as necessary to stabilise the
load.
12
6 50988078001 [EN]
To Next Page
