5 Operation
Working with attachments
Working with attachments
Fitting attachments
If the truck is equipped with an integrated
attachment (variant) at the factory, the specifi-
cations in the STILL operating instructions for
integrated attachments must be observed.
If attachments are fitted at the place of use,
the specifications in the operating instructions
of the attachment manufacturer must be
observed.
If an attachment is not deli
vered together
with the forklift truck, th
e specifications and
operating instructions o
f the attachment
manufacturer must be obse
rved.
Before initial commissioning, the function
of the attachment and the visibility from the
driver’s position with and without a load must
be checked by a competent person. If the
visibility is deemed insufficient, visual aids
such as mirrors, a camera/monitor system etc.
must be used.
NOTE
Please observe the definition of the following
responsible person: "competent person".
CAUTION
Attachments must be CE-certified. If the truck is
not fitted with an attachment-specific residual load
capacity rating plate and the operating devices are
not marked with corresponding pictograms, the
truck must not be used.
– Order the residual load capacity rating plate and
pictograms from your authorised service centre
in good time.
DANGER
There is risk to life caused by a falling load!
Attachments that hold the load by exerting pressure
on it (e.g. clamps) must be controlled additionallyby
a second operating function (lock) that is actuated
to prevent an unintentional release of the load.
If such an attachment is retrofitted, a second opera-
ting function for actuation must also be retrofitted.
– Make sure that the additional clamp locking
mechanism function is available.
13
4 50988078001 [EN]
To Next Page
