5 Operation
Lift height preselector (variant)
CAUTION
Risk of damage to property
It depends on conditions on site whether or not
an extension cable for connecting the battery to
the truck is required during battery replacement.
If an extension cable is required, only a cable with
an appropriate cross-section and approved plugs
must be used.
When an extension cable is in use, the operator
must take great care when positioning the truck not
to pull the cable out of the socket.
Lift height preselector (variant)
General
The lift height preselector supports the user
when placing loads into stock/removing loads
from stock. There are 160 programmable
levels grouped into eight areas (A-H), each
with 20 levels. After selecting one of these
levels, the user can read the following in the
display:
• Selected target level and area (1)
• Actual height (2)
• Target height or distance to target (with
pallet free lift included in the calculation) (3)
NOTE
The fork arms must be in the "0° position" to
ensure their height position is calculated cor-
rectly. The "Automatic tilt to centre position"
option is very useful for this!
15
6 50988078001 [EN]
To Next Page
Loading...
