Maintenance 6
General maintenance information
Maintenance - 3000 hours/every two years
At operating hours
Carried
out
3000 6000 9000 12000 15000
Chassis, bodywork and fittings
Examine the chassis, covers, support elements and mast mounting for cracksor
damage (visual inspection)
Check the overhead guard/cab and panes of glass for damage; check the visibility
through the glass
Check the controls, s
witches and joints for damage, and apply grease and oil
Check the driver’s seat, seat adjustment and protective covers for correct function
and for damage
Check the driver restraint system (option) for correct function and for damage, and
clean
Check the battery tray, lock and sensor for correct function and for damage
Check the reach carriage guides, rollers and stops, and adjust if necessary
Check the reach travel measuring system and limit stops
Check the drive and brake actuations (single and dual pedal) for correct function
and for damage Clean dust and dirt from the mechanisms
Load wheels
Check the wheels for damage, wear and ease of movement
Check the wheel mountings for operating noise and play
Check the wheel fastenings using a torque wrench
Drive wheel
Check the tyres for damage and wear
Check the drive wheel for damage and wear. Adjust the support height according to
wheel wear. Always readjust the supports after a wheel change
Tig
hten the wheel screws using a torque wrench (tightening torque: 195 Nm)
Gearbox
Visual inspection for leak tightness, mounting and external damage. Checkfor
operating noise.
Oil change (gearbox)
Lubricate the shaft stub gearing between the gearbox and traction motor
Traction motor, steering motor, pump motor
Visual inspection for mounting and external damage. Check for operating noise.
Clean the external fans. Functional test
Steering
50
988078001 [EN] 235
To Next Page
Loading...
