Operation 5
Handling the battery
The battery can be removed using the follo-
wing lifting accessories:
• Crane (with standard equipment)
• Change frame (with roller chan
nel variant
for side battery replacement)
The load capacity of the lifting accessory used
must at least match the battery weight (see
battery identification plate).
The removal of batteries from trucks without
their own devices must be carried out by the
authorised service centre.
Actuating the battery lock
Before the release lever for the battery lock
can be pulled, the battery lock must be re-
leased. The battery lock is released via the
"Retract reach carriage to the drive side" op-
erating function on the joystick 4Plus or via the
corresponding fingertip switch.
Releasing the battery lock
– Press and hold the foot
switch
– Use the actuating lever (joystick or fingertip
switch) to retract the reach carriage to the
drive side until the reach carriage stops.
– Continue to actuate the actuating lever
– After five seconds, t
he "lock" symbol (1)
appears on the displ
ay and operating
unit. This symbol in
dicates that the reach
carriage can now be r
etracted into the end
position in order to
release the battery
50
988078001 [EN] 197
To Next Page
Loading...
