5 Operation
Operating in special operating sit
uations
Hooking on the lifting straps to a truck without
aliftmast
• Attach two suitable shackles (4) in the upper
mast bearings of the truck
• Guide the lifting strap upward
s through
the two shackles and through th
estrutsof
the overhead guard. Make sur
e that no
pressure can be exerted on th
e overhead
guard by the lifting strap
• Guide the lifting straps upwards through
the two shackles and through the struts of
the overhead guard. Make sure that no
pressure can be exerted on the overhead
guard by the lifting strap Loop another lifting
strap around the two posts of the overhead
guard (5), (6) and guide the lifting strap
upwards
8
7
– Adjust the length of the harnesses so that
the lifting eye (7) is vertically above the
truck’s centre of gravity.
This ensures that the truc
k hangs level when
lifting it.
– Connect the lifting straps to the lifting eye
and insert the safety device (8).
CAUTION
Incorrectly fitted harnesses may damage attach-
ment parts!
Pressure from the harnesses can damage or
destroy attachment parts when the truck is lifted.
If attachment parts are in the way (e.g. lighting
etc.), these must be removed before loading. Ask
your service centre about this.
– Secure harnesses in such a way that they do not
touch any attachment parts.
18
8 50988078001 [EN]
To Next Page
