Operation 5
Decommissioning
– Lower the fork to the ground.
– Tilt the lift mast forwards until the tips of the
fork arms rest on the ground.
– If attachments (variant) are fi
tted, retract the
working cylinders.
– Turn the switch key (variant) to the left and
pull it out.
CAUTION
Risk of component damage!
If you remove the battery male connector while
the truck is switched on (under load), an arc will be
produced. This can cause the contacts to erode,
which considerably shortens their service life.
– Switch off the truck before the battery male
connector is disconnected.
– Do not disconnect the battery male connector
while the truck is switched except in the case of
an emergency.
1
– Disconnect the battery male connector.
NOTE
The switch key, FleetManager card (variant),
FleetManager transponder chip (variant) or
FleetManager PIN code (variant) must not be
passed to others unless explicit instructions to
this effect have been given.
50
988078001 [EN] 221
To Next Page
