3 Safety
Basic principles for safe operatio
n
Only restraint systems (variants) that have
been specifically approved by STILL may be
installed and used.
DANGER
Risk of injury if truck tips over!
Even if the driver has fastened the
seat belt (variant), there is still a
residual risk of injury if the truck
tips over. In addition, the seat belt
protects against the consequences
of rear-end collisions and falling off a
ramp.
– The seat belt (variant) must always
be used.
When carrying out welding work on the
truck, it is essential that the battery and all
connections to the electronic control cards are
disconnected. Contact the authorised service
centre on this matter.
In the event of the manufacturer going into
liquidation and the company not being taken
over by another legal person, the operating
company can make changes to the truck.
To do so, the operating company must fulfil
the following prerequisites:
Design documents, test documents and
assembly instructions associated with the
change must be archived and remain accessi-
ble at all times.
The capacity rating plate, decal information,
hazard warnings and the operating instruc-
tions must be checked to ensure they are
consistent with the changes and modified if
required.
The modification must be designed, checked
and implemented by a design office that
specialises in industrial trucks in accordance
with the standards and directives valid at the
time the modification is made.
Decal information with the following data must
be permanently affixed to the truck so that it is
clearly visible:
– Type of modification
– Date of modification
30
50988078001 [EN]
To Next Page
Loading...
