Operation 5
Checks and tasks to be carried out pr
ior to commissioning
cab (variant) must be undamaged and
securely mounted
• Attachments (variant) must be properly
attached and function according to their
operating instructions
• All decal information signs mu
st be in
place and legible. Replace d
amaged or
missing adhesive labels in a
ccordance with
the overview in the "Identifi
cation points"
chapter
• Any warning units (e.g. signal horn) must be
in perfect condition and function correctly
• Check the visible areas of the hydraulic sys-
tem for damage and leakages. Damaged
hoses must be replaced
• The battery frame must be fu
lly retracted
towards the drive side and m
ust be locked
securely in this position
• Check the battery male connector for
damage (e.g. cracks, breaks or deformation
of the housing, and whether the contacts
are bent or damaged). If necessary, have
the battery male connector replaced by the
authorised service centre
• With an internal roller channel (variant), the
swing bolt of the battery lock must be closed
and must not be damaged or deformed
• The battery frame must sh
ow no noticeable
damage (e.g. cracks or br
eaks)
• Steps must be clean and free of ice
• Any panes of glass (even for the weather
protection cab/cold store cab variant) must
be clean and free of ice
• Depending on the tyres,
the truck is fitted
with an earthing strap.
The earthing strap
must not be damaged. It m
ustalsobeclean
and long enough to touch
the ground
• Damage or other defects on the truck or
attachment (variant) must be reported to
the supervisor or responsible fleet manager
immediately so that they can arrange for the
defect to be rectified.
50
988078001 [EN] 57
To Next Page
Loading...
