Operation 5
Driving
designed for this purpose. However, movable
parts may project beyond the truck contour
and be damaged or torn off. Examples of such
components include:
• Extended lift mast
• Additional attachments (mirr
ors, monitors
etc. )
• Cab doors
Condition of the roadways
Roadways must be sufficiently firm, smooth
and even. The surface must be free from
dirt and fallen objects. Drainage channels,
level crossings and similar obstacles must be
evened out, and if necessary, ramps must be
provided so that trucks can drive over these
obstacles with as few bumps as possible.
Ensure that manhole cover
s, drain covers etc.
offer a sufficient load cap
acity.
The permitted area load and point load of the
roadways must not be exceeded. There must
be sufficient distance between the highest
points of the truck or the load and the fixed
elements of the surrounding area. The height
is based on the overall height of the truck’s lift
mast and the dimensions of the load.
Rules for roadways and the working area
It is only permitted to drive on routes autho-
rised for traffic by the operating company (see
chapter "Responsible persons") or its rep-
resentatives. Traffic routes must be free of
obstacles. The load must only be set down
and stored in the designated locations. The
operating company and its representatives
must ensure that unauthorised third parties do
not enter the working area.
Hazard areas
Hazard areas on roa
dways must be marked
by standard traffic
signs or, if necessary, by
additional warnin
g signs.
50
988078001 [EN] 89
To Next Page
Loading...
