Operation 5
Operation in special operating situations
1
3
2
6210_001-016
Determining the loading weight
– Park the truck so it is secured; see ⇒ Chap-
ter "Parking the truck securely", P. 5-171.
– Determine the loading weight of the truck.
– Read the following weights on the factory
nameplate, and if necessary, the factory
nameplate of the attachment, and perform
the addition:
Tare weight (1) + ballast weight (3) (if present)
+ tare weight of the attachment (if present) =
loading weight.
Attaching lifting straps
CAUTION
Failure to follow these instructions could result in
damaged components!
– Use textile harnesses and, if necessary, edge
protectors or similar protective equipment to
prevent damage to the truck.
DANGER
Risk of accident!
– Only use hoists and harnesses with adequate
lifting capacity for the determined loading weight.
– Only use the designated attachment points on
your truck!
– Make sure that harness parts such as hooks,
shackles, belts and similar items are only used
in the indicated load direction. The harnesses
must not be damaged by truck parts.
– Loop the lifting straps around the main tra-
verse (1) on the outer mast of the lift mast.
NOTE
The attachment points are indicated by a hook
symbol.
171673 [EN] 157
To Next Page
Loading...
Need help?
General
