99
STATIC NETWORK CONFIGURATION
When the Static wired network option is enabled you must manually configure the IP Address, Subnet Mask,
and Gateway Address fields for the printer (provided by the system administrator). Use the keypad to configure
this information; simply touch a field on the screen to select it and then use the keypad displayed to enter
network information. Touch anywhere on the screen outside of the keypad to exit and close the keypad. Press
the Apply button to save the network information configured. Once the Apply button has been pressed and
network information is saved, network information will not change.
When finished, press the Back button to exit and return to the Tools page.
Figure 4-80: Static Network Configuration
Note: See your system administrator if you do not know the IP address, Subnet
Mask, or Gateway Address.
To Next Page
Loading...
