163
MAINTENANCE SCHEDULE
Maintenance tasks must be performed on a regular basis in order to maintain optimal system operation. Table 7-
1 outlines the general maintenance schedule for the F123 Series. Detailed instructions for each task make up
the rest of this chapter.
Table 7-2 lists part numbers for various replacement consumable items. Use the part numbers listed in this table
when ordering replacement parts from Stratasys or your regional Stratasys office.
Table 7-1: Maintenance Schedule
Table 7-2: Replacement Consumables
Warning: Always wear proper heat protective clothing when working inside the
oven.
Weekly Monthly As Needed Maintenance Task
X
“Cleaning the Oven Chamber” on page 164
X
“Cleaning the Platen” on page 164
X
“Clean/Inspect Tip Wipe Assemblies” on page 165
X
“Cleaning the Exterior Surface of the Printer” on page 167
X
“Cleaning the Touchscreen Display” on page 167
Part Number Description
123-00300
Model Head (standard)
123-00300
Support Head (standard)
123-00307
PLA Model Head
123-00301
PLA Cooling Module
123-00302
F170 substrate 1 box of 16
123-00303
F270 substrate 1 box of 16
123-00304
F370 substrate 1 box of 16
123-00305
Tip shield kit - 4 sets
123-00306
2-pack of tip wipe assemblies (see
“Clean/Inspect Tip Wipe Assemblies” on
page 165
).
To Next Page
Loading...
