Stratasys F270 - Front Top Cover

173
FRONT TOP COVER
Required Tools
• 2 mm hex wrench
Removing the Front Top Cover
1. Power OFF the printer. See “Powering Off” on page 169.
2. Open the oven door to release the front top cover latch.
3. Open the front top cover.
4. Using a 2 mm hex wrench, remove the hinge mounting screws (4) from the crossbar.
See Figure 7-14.
Figure 7-14: Front Top Cover Hinge Mounting Screw Locations
5. Lift the front top cover up and away from printer to remove.
Installing the Front Top Cover
1. Align the front top cover hinges with the mounting locations on the crossbar. See Figure 7-14.
2. Using a 2mm hex wrench, reinstall the hinge mounting screws (4). See Figure 7-14.
3. Close the front top cover.